|
Perform the following procedure to configure the sending of status change events for systems when hardware status changes to and from a critical (unreachable) state only.
To configure status change event settings:
Select Options Status Change Event Settings. The Status Change Event Settings page is displayed. Two options are available on this page. Select either one or both of the options.
Enable creation of system status change events. This will cause a system unreachable event to be sent whenever a system cannot be reached by a ping through the Hardware Status Polling task. Enabling this will cause a system reachable event to be created whenever the system is reachable again.
Automatically clear unreachable system status change events when system is reachable. If this is enabled, when a system that was previously unreachable starts to respond, the previous unreachable event is marked with a cleared state.
Click [OK] to apply changes.
 | | Related Procedures |
| | Related Topics |
|
