Clusters
Configuring Node Resource Settings

Select OptionsCluster MonitorNode Resource Settings. The Cluster Monitor - Node Resource Settings page is displayed.

Select the cluster from the Cluster list at the top of the page. Select All to configure a resource the same for all clusters. To set polling values for CPU utilization or Disk capacity, the cluster choice must be set to All

Select the node from the Node list. Select All to configure a resource the same for all nodes in the selected cluster. As in the case of clusters in step 1, some resource attributes can only be set once for all nodes, and so require you to select all clusters and nodes; refer to the individual attribute descriptions for a particular resource.

Select the resource from the Resource list to display buttons for the resource configurable parameters.

Specify the appropriate resource options.

Note: HP recommends settings the polling rate to no less than five minutes.

Note: Refer to Cluster Monitor - Cluster Monitor Resource Thresholds for information about the Disk and CPU thresholds.

Note: If you select All from the Cluster list and select either CPU or Disk from the Resource list, you can set polling or threshold values. If you select Polling, set the value, then select Thresholds, set the values, and then select Polling again, the new polling values are still displayed. No matter when you click [OK] after setting the polling or thresholds values, these values are saved and not reset to the original value. This is the same when setting thresholds.

Click [OK] to save the changes.